ESD FLAT BELT CONVEYORS FOR

ASSEMBLY, TOUCH-UP AND PACKING

Double Sided Touch-Up Belt Conveyor

Standard Features:

• UMSCO’s Clear Anodized Aluminum Extrusion with "T" slots
• ESD endless safe belt, 24 inches wide
• Stainless steel belt support bed
• DC motor with variable speed controller
• Standard height of 32.0 inches
• Adjustable feet -+2" –1"
• Electrical is 110/120 volt, single phase, 60 cycle

Included Options:

1. Operators stations width of 48 inches
2. Laminated work surface ESD safe 12x48 with hole for solder iron
3. Solder bins at each operator station
4. Double sided chart holder ESD safe
5. Wiremold 4000 series with four plugs per operator
6. One inch air line with "T" for quick disconnect per operator
7. Rubber covered foot rest per operator
8. ESD plugs per operator
9. Two inch PVC vacuum line entire length of conveyor
10. Amber tower light with on-off switch per operator
11. One Red tower light will be provided
12. Lighted emergency stop button every other operator
13. This conveyor may be configured for 4 to 16 operator

Call us today for prices and options!!

Special Option for our Touch Up Belt Conveyor

This side bench fits up perfectly with the touch up belt conveyor shown above.

Features:

• UMSCO's Clear Anodized Alunimum Extrusion.
• ESD Laminate worksurface, 40" wide by 31" deep. Beige color to match the belt conveyor.
• Working height 32" with a +- 2".
• ESD Lexan and Aluminum Chart holder, 12" x 27".
• Rubber covered foot rest.
• ESD Banana plug.
• Price per bench, $725

"Modular" Final Assembly Conveyors:

UMSCO 8 Foot Modular Belt Conveyors

1. UMSCO’s Clear Anodized Aluminum Extrusion with "T" slots
2. Overall length of each conveyor will be eight foot
3. Belt width of 18.0 inches
4. Overall width of the conveyors is 26.25 inches
5. Height to top of belt is 36.0 to 39.0 inches
6. Adjustable feet from +3" to –0"
7. Four chart holders, mounted 15.0 inches below top of support bar
8. Amber status light, mounted below and in center of chart holders
9. 2000 series wire-mold with one plug per station, mounted on chart holder support bar
10. Operator station status light, amber
11. Tower status light; red, green and amber
12. Upper parts tray shelf, shelf to extend entire length of conveyor and have a 2.0 inch lip
13. 4000 series wire-mold, behind parts bin rail on vertical rail
14. Parts bin support rail, above and behind belt
15. Four banana jack, ESD plugs
16. Pivoting gravity roller racks mounted below belt
17. Over head florescent light fixtures
18. Adjustable tool hanger bar with four hangers
19. Audible alarm with a pleasing sound
20. All units compatible to slave or master mode
21. Emergency tape switch in front of and below belt on rail
22. Sheet metal bin holder on drive roller support plate
23. Recessed start/stop switch on control panel
24. Electrical is 120/110 volt, single phase, 60 cycle
25. Debris collector
26. Stop sensor mounted on end of conveyor

• Price per conveyor is ………………………………………………………….$ 14,250.

UMSCO loacated at 1301 Broadway NE , Albuquerque NM
Phone: , Fax: , E-Mail: UMSCO

[ Home | Products | Contents | Feedback | Search ]